|
Problems when generating the 3D model |
|
|
|
Information about 3D-Errors
|
If any errors occur while generating geometrical elements then the corresponding part in the model tree is marked by red color. |
Furthermore, a corresponding message is displayed in the Warnings panel.
Problem |
Possible solutions |
|---|---|
3D-Error: Could not create solid ... |
|
Distance tolerance is too low or too high |
Change the distance tolerance (see Model settings) |
Number of data points is disadvantageous (seldom) |
Change the number of data points for the 3D model (see Model settings) |
Eliminating errors during surface generation
For eliminating errors during surface generation there exists the following possibility:
| • | try a different number of data points for the 3D model (see Impeller- or Volute-Settings) |
| • | try a different display resolution (see Model display (top)) |
|
The pictures illustrate the possible influence of point density on the surface generation of the blade. |
Surface display errors
It may occur that a surface is not displayed although it exists.
You can recognize such cases, by selecting the surface in the model tree and choosing a high number of isocurves (see Model display (top)).
Normally, choosing another resolution (see Model display (top)) solves this problem.
|
The orange iso-curves show how the surface looks like. |
Slow 3D model
If the handling of the 3D model is very slow, normally an update of the graphic card driver is helpful.
|
If problems occur in connection with the graphic card, sometimes an unsteady mesh is displayed on the faces of the solids. |
Page url: http://www.cfturbo.com/fileadmin/content/manual/en/index.html?3dmodel_problems.html
